LED Panel Controller

$29.95

Panel-Controller , ,

Use this controller to  connect your Precision Detectors to activate a SINGLE Green/Red LED on your panel.  Only two wires from the LED to the controller per LED and simply connect the signal wire from any Precision Detector.  There is only one power INPUT for all the LEDs, The panels can be daisy chained .  The LED brightness can be adjusted.

The product image is a 3D rendering of the circuit board.  Standard price is WITHOUT a case but you can add one if you want. The case is 3D printed so it tends to be expensive for this part which will be buried inside the layout – and perhaps never touched again.  🙂

Use the same power module you use to power your detectors, signal controller and Block signals.  Power Modules have a 1amp capacity in total of all connected devices.

 

Shopping cart

close